Things you will need:

A spudger or 2, a teeny tiny phillips screwdriver, a teeny tiny torx screw driver, the broken phone, krazy glue, a new screen/digitizer, and patience.

Shut phone off, remove battery cover and take out battery. Remove the 4 T5 screws in each of the corners then separate the back cover. Remove the 4 philips screws from the board.

There are 3 ribbon cables, one on the right side on top of the main board, the second is in between the main board and the copper covering and the third connects the LCD to the main board. GENTLY detach the ribbons (I removed the copper plate to get to one, it’s easier that way).

Once all screws and ribbons removed, take your spudger and slowly peel back the LCD (its stuck with double sided tape.)

Remove all the broken glass from the frame. I covered mine in packing tape so the shards don’t go everywhere, a screen protector would be best for this.

After all the glass has been removed, clean off the double sided tape from the frame. You can carefully use goo gone, I just scraped it off.

Almost there! Now take the krazy glue, and apply it neatly to the frame (in small amounts) where the double sided tape was. Using too much will get it all over the frame and new glass, and that stuff is permanent. Gently and carefully lay your new screen on the frame, be sure to feed the ribbon through the hole (you may want to do that before using the glue). Let dry 3-5 minutes. Follow all the dis-assembly steps in reverse order, and Voila! good as new 🙂

No idea why the last photo smooshed on upload :\